5 Points about SMT solenoid valve maintenance of SMT mounter
SMT solenoid valve is an important part at SMT machine that can effectively implement the instructions issued by the host, in accordance with the signal to perform the exercise. Because it is a very high frequency of use of the parts, so it is prone to failure, in view of this situation, let’s share with you of below:
⑴ First of all to ensure that the SMT machine maintenance as much as possible in accordance with the instructions in the order to proceed. Because of accidental misuse can easily become the cause of SMT mounter damage and the machine movement malfunction.
⑵ SMT mounter installation and removal of compressed air supply and exhaust. When we remove the pick&place machine, be sure to set the device to prevent the driven object from falling and misoperation, and then cut off the supply of air and power, in addition to the need to set the residual pressure discharge function of residual pressure in the system.
Finally, wait until it is installed or changed again and then restarted. We also need to determine if various measures have been taken to prevent the flying of the drive components. In addition, it is necessary to determine whether the machine has normal operation.
⑶ Low-frequency use, in order to effectively prevent the malfunction then please switch the SMT solenoid valve every 30 days to conduct a check, where attention must be careful air source.
⑷ In the manual operation, the operation of the device connected to the beginning will start to move. Here we need to determine the safety of the pick and place machine and then operate again.
⑸ Pick and Place machine condensate release, please remember to regularly exclude the stored condensate in the air filter .
If you like this post ,please click the” like button” to support us .Thank you .